Prep
We grind the whole slab, open up cracks and fill them, patch pits and test for moisture.
The system
Primer, a colored base coat, chips if you want them, and a clear topcoat. For garages with a boat trailer or heavy tool chests, we add extra build. The crew at Lynwood Epoxy Flooring Pros describes a similar layer-by-layer garage build if you want to compare how other shops approach it.
Three-car garages
Bigger floors take a bit longer, but the price per square foot usually goes down.
Keeping the wind out
We work with the door nearly closed in the afternoon so blowing dust does not land in wet coating.
How long until I can park?
About a week.
Can it handle jack stands?
Yes; use pads under them.
Freezers and workbenches
Garage freezers and heavy benches can sit right on the new floor after cure. Use pads under feet.
Clean up
Hose and squeegee or mop with mild soap.
What to expect from garage floor epoxy in Antioch
A lot of garages here hold more than cars. We see fishing gear for weekends on the Delta, bikes for the trails at Black Diamond Mines, freezers, and home gyms. The coating has to handle all of that, plus hot tires rolling in after a 100-degree commute on Highway 4.
Our usual build
We diamond grind the slab, treat cracks with a flexible or rigid filler depending on whether they move, then lay a moisture-tolerant primer, a pigmented body coat with flake, and a UV-stable clear top. The result is thick enough to resist hot tire pickup, which is the most common way thin coatings fail in East County garages.
Questions homeowners ask
Should I wait until fall? No need. We work through summer by starting early, before the garage heats up, and choosing products suited to the temperature.
Will my cracks come back? Cracks caused by soil movement can reappear as fine lines. We will tell you which ones we expect to stay put and which may show again.
How do I care for it? Sweep or blow it out, and wash with water and a mild cleaner. Skip citrus degreasers on the clear coat.
Prepping for install day
Empty the garage, unplug anything on the floor, and plan where cars will park for a few nights. We handle the taping, the grinding and the clean-up afterward.
Cabinets and storage
Planning wall cabinets? Install them after the floor cures so the coating runs underneath cleanly.
Garage coatings sized for East County homes
Antioch garages tend to be large, and that changes how a coating job is planned. A three-car garage has more joints, more square footage to grind and more chance of cracks across the slab. We look at the whole floor, mark every repair, and walk you through the plan before any work starts.
Prep on a builder-grade slab
Many tract-home slabs were finished smooth and dense, sometimes with a curing compound or sealer on top. Coatings do not bond well to that surface. We grind it to a profile that lets the base coat grip. If there is old paint, it comes off completely. Oil spots get degreased and ground back.
Picking a look
Many homeowners choose a chip finish because it hides dust and tire marks on a busy floor. Others want a solid gray for a workshop look. We bring samples and set them down in your garage so you can see how they look in your light, which can be harsh on a sunny afternoon.
Planning around your vehicles
We schedule the job so you know exactly when the cars and boat need to be out and when they can come back. Hot weather speeds cure times; cool weather slows them. We adjust the plan based on the forecast.
Upkeep
Regular sweeping and an occasional mop keep the floor looking good. Clean up fuel or oil spills when you see them. That is about all the maintenance a coated floor needs.
Get your garage quote
Call (925) 350-7154.